中华彩票投注

行業動態【ENTERPRISE NEWS】

當前位置:網站首頁 > 新聞資訊 > 行業動態
  • 安裝輕質隔墻板構件要求
  • 本站編輯:杭州久泰建材有限公司發布日期:2019-09-20 13:19 瀏覽次數:
安裝構件要求
1、頂端與梁底用U型鐵件固定,將U型鐵件用射釘固定在梁底部,上端用木楔加固,用L型鐵件固定。
2、吊掛設計:吊掛間距不應小于300m,單點承重不應大于80公斤,需先開口埋件。
3、電氣設計:電氣線路可作暗線設計,利用隔墻板孔穿軟管敷設線路;也可作明線設計,敷于墻面,開口插座與其相應配置。
4、防潮防水:飾面設計應考慮防潮防水,沿墻邊設計水池、水箱、面盆等附件時,墻面應涂刷防水涂料或貼瓷磚等防水飾面設計。
5、墻面裝修:可刮大白、噴瓷、貼瓷磚等裝飾材料進行裝修。進行下道工序裝修時,先清理隔墻板墻面,灑水潤濕,按常規的施工工藝進行裝修  。

Installation Component Requirements
1, the top and the bottom of the beam are fixed with U-type iron pieces, the U-type iron pieces are fixed with nails at the bottom of the beam, the upper end is reinforced with wood wedges, and the L-type iron pieces are fixed.
2, hanging design: hanging spacing should not be less than 300M, single point load should not be greater than 80 kg, need to open and bury the piece first.
3, electrical design: electrical lines can be used for dark line design, using the wall panel Kongchuan hose laying line; It can also be used as a bright line design, applied to the wall, opening socket and its corresponding configuration.
4, moisture-proof waterproof: the design of the finish should be considered moisture-proof waterproof, along the wall edge design pool, water tank, basin and other accessories, the wall should be painted waterproof paint or tiles and other waterproof finish design.
5, wall decoration: can scratch white, spray porcelain, paste tile and other decorative materials for decoration. When the next procedure is decorated, clean the wall of the partition first, sprinkle water and moisten it, and decorate it according to the usual construction techniques.